My plan is to build out forces for the following:
- Canadian Army
- French Army
- German Army
- USMC
- Russians
The idea is to have a platoon sized force for each, with armoured transports, IFVs, and tanks. I have just a few odds and ends to take care of for my Iraqi project, but for the most part it is complete, so on to Russia Resurgent!
For the French force I've ordered a full platoon with support from Eureka Miniatures. I'm using the French Foreign Legion figures in helmets for regular French units. I will likely expand this in the future and order the FFL figures in berets to represent the FFL units. French armour is not found easily, but Gaso.Line in Europe does 1/48th scale kits for all French armour, which is great. It will be just a tad larger than 1/50, but I've seen lots of 1/48 scale kits used with Empress vehicles and miniatures and they look fine. Also, to get 3D modelling done for all the vehicles and then get them printed would cost me a small fortune, so I ordered the following kits ...
Leclerc MBT |
ERC 90 Sagaie |
VBCI |
VAB |
AMX 10 RC Giat |
On a separate note, I've been looking for 1/48th scale rutsacks to adorn the sides of my vehicles and I finally found them on the same site that has the French armour ...
US modern equipment 4 |
I'll be casting the rutsacks so I can mass produce them for the sides of my vehicles.
I'll also be doing Canadians using the Full Battle Rattle Miniatures range that is due out in mere weeks! Check out their Facebook page. I'll be doing a full platoon ... and I have some conversion ideas for support weapons.
I'm using the Leopard 2A6 from Empress Miniatures and I'll be converting the LAV 25 that Empress sells into the LAV III's used by Canada (minor conversion work).
I've had a Canadian G-Wagen 3D modeled (and have them in hand now and they turned out great). You can purchase you own from Shapeways here.
I've had a Canadian G-Wagen 3D modeled (and have them in hand now and they turned out great). You can purchase you own from Shapeways here.
I've already ordered and have a significant Russian force on the way from Empress Miniatures. This includes:
- Full three section rifle platoon with support
- 3 x T-90
- 3 x T-80
- 3 x BMP-3
- 1 x BTR 80
- 1 x BTR 80A
- 1 x ZSU-23-4 Shilka (from HLBS)
- 1 x MIL-24D Hind (from Amazon)
I'll use the Eureka Miniatures Bundeswehr range for the Germans. I haven't tried to track down any of the German armour yet (other than I know Empress has the Leopard 2A6 that I will use again for the Germans). More on this in a future post.
Last but not least is the USMC. Since I already have this force for Iraq, I figured I'll do them last but I will do them as it wouldn't be "Russia Resurgent" if the US didn't show up to the party.